Filter
Top Products
LS9 Editor Owner’s Manual
44
❏ TO MATRIX
These are the same as the TO MATRIX of a MIX channel (➥ p.37).
❏ BALANCE (except for MONO channel)
This adjusts the left/right volume balance in the STEREO bus. You can set this to the center value by holding
down the <Ctrl>(< >) key of your computer keyboard and clicking this knob.
❏ EQUALIZER
This is the same as the equalizer settings of a MIX channel (➥ p.39).
❏ DYNAMICS1
Except for the fact that the available types are COMPRESSOR, EXPANDER, COMPAND H and COMPAND S,
and that you can select more than one signal as the key-in signal, this is the same as the dynamics for input chan-
nels (➥ p.31).
❏ INSERT
Except for the fact that the insert points that can be selected are different, this is the same as for the insert settings
of an input channel (➥ p.35).
❏ RECALL SAFE/MUTE SAFE
These are the same as the RECALL SAFE/MUTE SAFE of a MIX channel (➥ p.40).
❏ MUTE GROUP
These are the same as the MUTE GROUP of a MIX channel (➥ p.40).
❏ Fader
A ON
This switches the STEREO/MONO channel on/off. This is
linked with the STEREO/MONO MASTER section [ON]
keys on the LS9’s panel.
B Fader
Adjusts the output level of the STEREO/MONO channel.
This is linked with the STEREO/MONO MASTER section
faders of the LS9’s panel. A meter indicating the signal level is
shown at the right of the fader, and the current value is
shown in the numerical box immediately below.
CCUE
This button cue-monitors the signal of the STEREO/MONO
channel. This is linked with the STEREO/MONO MASTER
section [CUE] keys on the LS9’s panel.
1
2
3
1
2
3
STEREO MONO