Filter
Top Products
5. If RS-232 is selected in step 3:
a. Click the com port drop-down list and select the PC comm port connected to
the rear panel RS-232 port.
b. Check the baud rate displayed in the Com Port selection window. If the baud
rate does not match the device’s rate, click the Baud Rate drop-down menu and
select the desired baud rate. The default is 38400.
c. Click OK.
The Synchronize with Device dialog box (see figure 53 on page 79) appears.
Proceed to step 7.
6. If USB is selected in step 3:
a. Click the USB Device drop-down menu and select DMP 64 (or Extron USB
device, if DMP 64 is not available),
b. Click OK.
The Synchronize with Device dialog box (see figure 53) appears.
Proceed to step7.
DMP64 • Software Control 78