Filter
Top Products
11
MR-8 Owner’s Manual
4. [PHONES] jacks (1, 2)
Two jacks (1 and 2) are provided. You can use
two pairs of stereo headphones with the MR-8.
5. [PHONES VOL] control
Adjusts the headphone output level.
6. [REVERB/DELAY TIME] control
Controls the reverb time or delay time (see page
40).
7. [EFFECT] keys
Select the effect type from among ROOM, HALL,
PLATE and DELAY (see page 39).
8. [MASTER] fader
Adjusts the stereo (L and R) buss output level
(see page 32 and 33).
9. Track faders
Each fader adjusts the appropriate track play-
back level. Each of track faders 5/6 and 7/8
controls the appropriate stereo signal (see page
19, 32, and 33).
10. [REC SELECT] keys
Used to select one or two recording tracks.
You can record onto up to two tracks simulta-
neously. Pressing a key arms or unarm the cor-
responding track(s). Tracks 5/6 or 7/8 are armed
or unarmed simultaneously (see page 29, 31, and
33).
11. [PAN] controls
Control panning for tracks 1 through 4 (see page
45).
12. [EFFECT SEND] controls
Control the amount of signals from tracks 1
through 4 sent to the internal effect (reverb/de-
lay). (see page 40).
13. Internal microphone
You can make recording using the internal mi-
crophone by setting the [INPUT A SELECT] switch
on the rear panel to "INT MIC" (see page 29).
14.Insert effect select keys
Used to select the insert effect (mic simulation
or amp simulation) for the signal from the [IN-
PUT A] jack.
When setting the [INPUT A SELECT] switch on
the rear panel to "MIC/LINE", you can use the
mic simulation effect. When setting the switch to
"GUITAR", you can use the amp simulation ef-
fect (see page 30 and 38).
15.[DISTORTION] control
Controls the amount of the distortion effect for a
guitar connected to the phone jack on the [IN-
PUT A] section.
This control is effective only when the [INPUT A
SELECT] switch is set to "GUITAR" (see page 30).
16.[TRIM] controls
Control the input gain of the [INPUT A] and [IN-
PUT B] sections (see page 30).