Filter
Top Products
93
MR-8 Owner’s Manual
<Trouble 5>
During overdubbing, the playback signal of
the recorded track cannot be monitored.
• Is the track fader for the playback track brought
up?
During overdubbing, bring up the faders
for both the playback and recording tracks
appropriately. Otherwise, you cannot make
overdubbing while listening to the recorded
track(s) (see page 34).
<Trouble 6>
Auto punch in/out cannot be executed.
• Is " " shown on the screen?
If it is not, press the [AUTO PUNCH] key to
make the auto punch in/out function
active.
• Are the punch-in and punch-out points set
correctly?
To check each point, press the [LOCATE A/
IN] or [LOCATE B/OUT] key.
The recorder locates to the punch-in or
punch-out point, while the screen shows the
appropriate time data. If the punch-out
point is earlier than the punch-in point, set
these points appropriately so that the
punch-in point is earlier than the punch-
out point (see page 36).
Troubles for playback
<Trouble 1>
During playback, the recorder suddenly ex-
ecutes locating.
• Is "
" or " " shown on the
display?
If so, the play mode is set to the auto
return or loop mode.
Press the [PLAY MODE] key until "Off" is
selected (see page 50).
<Trouble 2>
Cannot monitor the playback sound.
• Are the track fader(s) for the playback track(s)
and the [MASTER] fader brought up to the
appropriate positions?
You cannot hear the sound of a playback
track if either of the corresponding track
fader or the [MASTER] fader is set at the
minimum position. If you monitor via
headphones, the [PHONE VOL] control also
have to be brought up (see page 32 and
34).
<Trouble 7>
Cannot record audio data of a song onto an
external digital recorder.
• Is the digital recorder set correctly for
recording the signal fed to the digital input.
See the manual of the digital recorder for
details about the setting.
• Did the song data you are going to record onto
the digital recorder created by the normal mode
(44.1-kHz, 16-bit)?
Only song data created by the normal mode
can be output from the [DIGITAL OUT]
connector.
Song data created by the extended mode
(22.05-kHz, 16-bit) cannot be digitally
output.
• Is the connection between the [DIGITAL OUT]
connector on the MR-8 and the optical input
connector of the digital recorder made correctly?
Check the connection, as well as the optical
cable (see page 48).