Filter
Top Products
69
MR-8 Owner’s Manual
TRK 1
TRK 2
TRK 3
TRK 4
TRK 5
TRK 6
TRK 7
TRK 8
Silent
LOCATE A
point
LOCATE B
point
REC END
ABS ZERO
You can erase a desired part on the selected mono
or stereo track(s).
<Note>
You cannot erase a part of a song protected.
Release the protection before erasing the part.
1) Load the song you want to edit.
2) Store the LOCATE A and LOCATE B points (see
page 53).
You can check the part by playing back between
the LOCATE A and LOCATE B points (see page 68).
3) While the recorder is stopped, press the [MENU]
key to enter the menu mode.
The display shows the menu selection screen, in
which "System" is highlighted initially.
4) Use the [CURSOR ] key to highlight "Part", then
press the [ENTER] key.
The display now shows the screen for selecting the
target track(s) which the desired part to be erased
belongs to. The current position information (in ABS,
Bar/Beat or time counter base) is shown at the top
of the screen.
6) Use the [CURSOR / ] keys to select a mono track
or a pair of stereo tracks.
You can select from among mono tracks (1 through
8) and stereo pair tracks (1/2, 3/4, 5/6 and 7/8).
7) Use the [CURSOR ] key to move the cursor to
"[ENTER]" at the lower right on the screen, then
press the [ENTER] key.
8) Press the [ENTER] key.
The display returns show to the screen in which
"Erase Part" is highlighted.
9) Press the [MENU] key to exit the menu mode.
<Note>
If you are not satisfied with the result, press
the [UNDO/REDO] key to undo the opera-
tion (see page 68).
5) While "Erase Part" is highlighted, press the
[ENTER] key.
The display now shows the part edit menu selec-
tion screen, in which "Erase Part" is highlighted ini-
tially.
The display shows "Please Wait!", immediately fol-
lowed by "Completed!" when the MR-8 completes
erasing.
If you want to cancel the erase operation, move the
cursor to "[CANCEL]" on the screen, then press the
[ENTER] key.
Erasing a desired part
flashing