Filter
Top Products
80
MR-8 Owner’s Manual
5) Use the [CURSOR / ] keys to enter "4".
6) Use the [CURSOR
] key to flash "4/4" for "Sig."
setting.
You can select a desired signature from among 1/4,
2/4, 3/4, 4/4, 5/4, 1/8, 2/8, 3/8, 4/8, 5/8, 6/8,
7/8 and 8/8.
7) Use the [CURSOR / ] keys to enter "3/4".
8) Use the [CURSOR
] key to move the cursor to
"[ENTER]" at the lower center of the screen, then
press the [ENTER] key.
The bar and signature setting above is completed
and the display changes to show the signature map
screen, in which the new setting is reflected.
9) Use the [CURSOR ] key to highlight "---bar -> ---",
then press the [ENTER] key.
The display shows the screen for new signature
setting as step 4 above. Follow the same procedure
as described above until you finish all settings.
You can make up to 64 bar/signature settings.
10) After completing all settings, use the [CURSOR ]
key to return the display to show the screen in which
"Signature Map" is highlighted.
Then, continue to the procedure for tempo setting
described on page 82.
To edit the signature map you created, see below.
Changing the bar number or signature
You can change the bar number or signature you
specified.
1) While the display shows the signature map screen,
use the [CURSOR / ] key to highlight the setting
you want to change, then press the [ENTER] key.
The display changes to show the screen where the
bar number flashes, showing that you can now edit
it.
flashing
flashing
flashing
flashing
flashing