Filter
Top Products
74
MR-8 Owner’s Manual
5) Use the [CURSOR ] key to highlight "Move Part",
then press the [ENTER] key.
The display now shows the screen for selecting the
source track(s) and destination track(s) of the move
operation. "Source Track" selects the move source
track(s), while "Dest. Track" selects the move
destination track(s).
6) Use the [CURSOR / ] keys to select the move
source track(s).
You can select from among mono tracks (1 through
8) and stereo pair tracks (1/2, 3/4, 5/6 and 7/8).
7) Use the [CURSOR ] key to move the cursor to the
option for "Dest. Track".
8) Use the [CURSOR
/ ] keys to select the move
destination track(s).
If you select a mono track for the move source in
step 6 above, you can select a mono destination
track. If you select stereo pair tracks for the move
source in step 6 above, you can select stereo pair
destination tracks.
9) Use the [CURSOR ] key to move the cursor to
"ENTER" at the lower right on the screen, then press
the [ENTER] key.
10) Press the [ENTER] key.
The display returns show to the screen in which
"Move Part" is highlighted.
11) Press the [MENU] key to exit the menu mode.
<Note>
If you are not satisfied with the result, press
the [UNDO/REDO] key to undo the opera-
tion (see page 68).
The display shows "Please Wait!", immediately fol-
lowed by "Completed!" when the MR-8 completes
the move operation.
To cancel the move operation, move the cursor to
"[CANCEL]" at the lower left on the screen, then press
the [ENTER] key.
<Note>
You cannot select the same track(s) for the
move source and destination.
flashing