Filter
Top Products
34
MR-8 Owner’s Manual
6) While playing the keyboard, adjust the recording
level using the [TRIM] controls on the [INPUT A]
and [INPUT B] sections.
The screen shows the input levels of tracks 5 and 6,
as well as the output levels of the stereo outputs (L
and R). Turning the [PHONES VOL] control clock-
wise raises the headphone monitor level.
<Note>
Adjust each of the [TRIM] control properly so
that the PEAK indicator does not light at the
loudest part of the keyboard sound. If the in-
put level is too high, the PEAK indicator lights
and the sound may be distorted or noisy.
Starting recording
7) While holding down the [RECORD] key, press the
[PLAY] key to start recording.
<Note>
When the recorder starts running, the
meter for track 1 (onto which you recorded
the guitar) shows the playback level. By
raising the fader for track 1, you can record
the keyboard onto tracks 5-6 while listen-
ing to the guitar on track 1 (i.e. overdub-
bing).
8) When finishing recording, press the [STOP] key to
stop the recorder.
<Tips>
After completing recording, press the [REC SE-
LECT] key for tracks 5/6 to unarm tracks 5/6.
Playing back the recorded tracks
9) While holding down the [STOP] key, press the
[REWIND] key.
The recorder instantly locates to the beginning of
the song and stops.
10) Press the [PLAY] key to start playback.
You can adjust the monitor level using the fader for
tracks 5/6, [MASTER] fader or [PHONES VOL]
control.
If you are not satisfied with the result, use the undo/
redo function to cancel the recording and try again.
If you are satisfied with the result, make recording
onto the other track(s) by following the same
procedure.
ENTER
MENU
CURSOR
UNDO
/REDO
CONTRAST
0 RETURN
TIME BASE
SELECT
STORE
PLAY
REWIND F FWD
MASTERING
-1
+1
J K L 4
Y Z 9
V W X 8
S T U 7
NO
YES
[UNDO/REDO] key
Undo/redo
If you press the [UNDO/REDO] key after finish-
ing recording, you can return to the condition
before the recording started (UNDO operation).
Therefore, you can try recording again.
If you press the [UNDO/REDO] key again (after
UNDO), the undo operation is canceled and you
can return to the condition when the recording
finished (REDO operation).
<Notes>
The undo/redo function can be used for all kind of
recordings, however, if you carry out any of the fol-
lowing operations after making recording, you cannot
undo the recording.
• Carrying out new recording.
• Carrying out new editing.
• Turning off the power.
• Carrying out song select, song delete or song
name editing.