Filter
Top Products
71
MR-8 Owner’s Manual
8) Press the [ENTER] key.
The display returns show to the screen in which
"Copy Part" is highlighted.
9) Press the [MENU] key to exit the menu mode.
• Pasting clipboard data
1) Store the LOCATE A point where you want to paste
the data (see page 53).
4) While "Paste Part" is highlighted, press the
[ENTER] key.
The display now shows the screen for selecting the
track(s) to which you want to paste the data.
5) Use the [CURSOR / ] keys to select the desired
track(s).
If you select a mono track for the copy source, you
can select a mono destination track. If you select
stereo pair tracks for the copy source, you can
select stereo pair destination tracks.
6) Use the [CURSOR ] key to move the cursor to
"[ENTER]" at the lower right on the screen, then
press the [ENTER] key.
7) Press the [ENTER] key.
The display returns show to the screen in which
"Paste Part" is highlighted.
8) Press the [MENU] key to exit the menu mode.
<Note>
If you are not satisfied with the result, press the
[UNDO/REDO] key to undo the operation (see
page 68).
3) Use the [CURSOR ] key to highlight "Part", then
press the [ENTER] key.
2) While the recorder is stopped, press the [MENU]
key to enter the menu mode.
If you paste the data to the same position as the
copied part, you can skip this step (because you
have already stored it as the LOCATE A point be-
fore the copy operation).
The display shows the menu selection screen, in
which "System" is highlighted initially.
The display now shows the part edit menu selec-
tion screen, in which "Paste Part" is highlighted ini-
tially.
The display shows "Please Wait!", immediately fol-
lowed by "Completed!" when the MR-8 completes
the paste operation.
To cancel the paste operation, move the cursor to
"[CANCEL]" at the lower left on the screen, then press
the [ENTER] key.
<Note>
If you are going to carry out the paste operation
when no data is pasted on the clipboard, the er-
ror message (“
Clip board Empty!
”) is shown on the
display and the MR-8 does not accept the opera-
tion. Press the [MENU] key to exit the menu mode
and copy the desired data to the clipboard be-
fore carrying out the paste operation.
flashing