Filter
Top Products
67
MR-8 Owner’s Manual
flashing
"Source Track" selects the exchange source track(s),
while "Dest. Track" selects the exchange destination
track(s).
The current position information is shown at the
top of the screen (shown in Bar/Beat base in the
screen example below).
5) Use the [CURSOR / ] keys to select the source
track(s) to be exchanged.
You can select from among mono tracks (1 through
8) and stereo pair tracks (1/2, 3/4, 5/6 and 7/8).
6) Use the [CURSOR ] key to move the cursor to
the option for "Dest. Track".
7) Use the [CURSOR / ] keys to select the
destination track(s).
If you select a mono track for the exchange source
in step 5 above, you can select a mono destination
track. If you select stereo pair tracks for the
exchange source in step 5 above, you can select
stereo pair destination tracks.
8) Use the [CURSOR ] key to move the cursor to
"ENTER" on the screen, then press the [ENTER]
key.
The display shows "Please Wait!", immediately
followed by "Completed!" when the MR-8 completes
the exchange operation.
<Note>
If you want to cancel the exchange opera-
tion, move the cursor to "
[CANCEL]
" on the
screen, then press the [ENTER] key.
9) Press the [ENTER] key.
The display returns show to the screen in which
"Change Track" is highlighted.
10) Press the [MENU] key to exit the menu mode.
<Note>
If you are not satisfied with the result, press
the [UNDO/REDO] key to undo the opera-
tion (see page 62).
<Note>
You cannot select the same track(s) for the
exchange source and destination.