Filter
Top Products
Basic Guide
13
IntroductionFront and rear panelConnectionsPlayingEditing
Playing a program
Here’s how to select and play a program.
The MS2000/MS2000R contain a total of 128 programs, with 16 programs in each of eight banks (A–H).
You can select programs in Program Play mode. If the LCD screen shows that you are in LCD Edit mode or Global mode,
press the [EXIT] key.
The method of changing the program or pitch differs between the MS2000 and the MS2000R. Also, the SELECT [1]–[16] keys
can be used to play a program only on the MS2000R.
MS2000
1. Select a program
There are two ways to select a program.
a. Using the BANK [UP] [DOWN] keys and the SELECT
[1]–[16] keys
This method lets you directly select the desired program.
1 Use the BANK [UP] [DOWN] keys to select the desired
program bank.
Pressing these keys will switch between banks A–H. The
selected bank will be shown in the LCD screen.
2 Use the SELECT [1]–[16] keys to select the desired pro-
gram number.
The numbers above each key correspond to the program
number.
b. Using the [+/YES] [–/NO] keys
● Press the [+/YES] key.
Each time you press the key, the program number will
increase by one.
● Press the [–/NO] key.
Each time you press the key, the program number will
decrease by one.
2. Changing the pitch sounded by the key-
board in one-octave steps
The pitch assigned to the keyboard can be changed over a
range of ±2 octaves.
a. Raising the pitch
● Press the OCTAVE [UP] key.
Pressing the key once will make the key LED light green,
and the pitch will be one octave higher.
Pressing the key twice will make the key LED light red,
and the pitch will be two octaves higher.
To return to the original pitch, press the [DOWN] key.
b. Lowering the pitch
● Press the OCTAVE [DOWN] key.
Pressing the key once will make the key LED light green,
and the pitch will be one octave lower.
Pressing the key twice will make the key LED light red,
and the pitch will be two octaves lower.
To return to the original pitch, press the [UP] key.
The setting of the BANK/OCTAVE [UP][DOWN] keys
cannot be saved for individual programs. If you wish to
change the pitch for a specific program, use the LCD
Edit mode Page 04A: PITCH “Transpose” parameter.
(☞Parameter guide p.36, Page 04A: PITCH “Trans-
pose”)
1
2
Single
=120
A01:MS2000