Filter
Top Products
Parameter Guide
51
With a setting of 0, keyboard tracking will not affect the vol-
ume.
Keyboard Track operates according to the pitch that is
controlled by pitch bend, transpose, and Mod Sequence.
It is not affected by pitch changes produced by vibrato
or Virtual Patch.
■ EG (Envelope Generator)
These parameters are the same as for a synth program.
Refer to “3. SYNTH Parameters.”
■ LFO (Low Frequency Oscillator)
These parameters are the same as for a synth program.
Refer to “3. SYNTH Parameters.”
■ CH PARAM
These set the output level and panning (panpot) for each of
the sixteen filters of the carrier (synth).
To make settings, use the CH PARAM [SELECT] key and the
sixteen knobs, or the CURSOR[√][®] keys and the [+/YES]
[–/NO] keys.
A: Ch Level
Specify the output level for each filter of the carrier.
Channel..........................................................[01...16]
Select the filter for which you wish to make settings.
Level ..........................................................[000...127]
Specify the output level of the filter.
A: Ch Pan
Specify the panpot for each filter of the carrier.
Channel .........................................................[01...16]
Select the filter for which you wish to make settings.
Pan....................................................[L63...CNT...R63]
Specify the panning of each filter.
■ EFFECTS
These parameters are the same as for a synth program.
Refer to “3. SYNTH Parameters.”
■ ARPEGGIATOR
These parameters are the same as for a synth program.
Refer to “3. SYNTH Parameters.”
■ UTILITY
A: InitProgram
This function initializes the settings of the currently selected
vocoder program (program common, timbre, effect, arpeg-
giator).
When a vocoder program is initialized, its voice mode will
remain at Vocoder.
For the procedure refer to “3. SYNTH Parameters.”
Page10: EG 1
Page11: EG 2
Page12: LFO 1
Page13: LFO 2
Page14: CH LEVEL
14A CH LEVEL
CH[01]: 060
Channel
Level
Page15: CH PAN
Page16: MOD FX
Page17: DELAY FX
Page18: EQ
Page19: ARPEGGIO
Page20: UTILITY
15A CH PAN
CH[01]: CNT
Channel
Pan
Program parameters