Filter
Top Products
Parameter Guide
43
C: Run Mode............................................[1Shot, Loop]
Specify whether the sequence will be looped for playback.
1 Shot
The sequence will play back for only one cycle, and will
hold the value of the last step.
Loop
The sequence will play back as a loop, using the sequence
type specified by “Seq Type.”
During Motion Rec, the sequence will always play back
in Loop mode.
D: Key Sync...................................[OFF, Timbre, Voice]
Specify how the sequence will be reset when note-on occurs
(when a key is played).
OFF
The sequence will not be reset when note-on occurs.
Timbre
At the first note-on that occurs from a condition of all
notes off, the sequence will be reset for the timbre that is
sounding.
In the case of a Split program, the timbre that is assigned
to the key for which the note-on occurred will be reset.
Voice
Reset will occur for each voice for which there is a note-on.
If the sequence and the arpeggiator are both on, you
should set this parameter to either OFF or Timbre. If
you select Voice, the sequence will be reset each time the
arpeggiator sounds. If you select Timbre, the sequence
will be reset at each chord change.
E: Resolution.............................................[1/48...1/1]
Specify the sequence playback speed as a proportion of the
tempo set by the [TEMPO] knob (or MIDI clock). (☞P.66
“How “Resolution” and “Sync Note” values correspond to
note values”)
At a setting of 1/1, the sequence will advance one step every
four beats.
At a setting of 1/2, the sequence will advance one step every
two beats.
At a setting of 1/4, the sequence will advance one step every
beat.
At a setting of 1/8, the sequence will advance two steps every
beat.
At a setting of 1/16, the sequence will advance four steps
every beat.
At a setting of 1/32, the sequence will advance eight steps
every beat.
A: Knob ................................. [None, Pitch...Patch4 Int]
Select the parameter that will be recorded in the sequence.
None
The sequence will have no effect on anything.
Pitch
The sequence will modify the overall pitch of the oscillator
in a range of ±24 semitones.
Step Length
The sequence will modify the length of each step as speci-
fied by SEQ COMMON “Resolution” in a range of ±6.
Other
The sequence will modify the value of the corresponding
parameter assigned to a panel knob, in a range of ±63 (or
±24 in the case of OSC2 Semi).
If the same parameter is specified for two or more
sequences, an “*” will be displayed in the upper right of
the LCD screen, and the assignment to the higher-num-
bered sequence (SEQ3 > SEQ2 > SEQ1) will take priority.
B: Motion .............................................. [Smooth, Step]
Select how change will occur when the sequence is played
back.
Smooth
The value recorded at each step will change in a smooth
linear fashion.
Step
The recorded value will be held until the next step is
played.
C: Step Value
Here you can modify the sequence data that is recorded in
each step.
To modify the data you can use the SEQ EDIT [SELECT] key
and the sixteen knobs, or the CURSOR[√][®] keys and the
[+/YES] [–/NO] keys.
Step Number..................................................[01...16]
Specify the step.
Page19: SEQ1
Page20: SEQ2
Page21: SEQ3
1
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Step
Smooth
1
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Step
Step
19C SEQ 1
Step[01]: +10
Step Number
Value
Program parameters