Filter
Top Products
23
CHAPTER
1
English
23
English
CHAPTER
5
SYNCHRONIZATION
At most of today’s dance clubs and events, the DJ will mix the songs together using a
technique called beat-matching. The goal is to fade the volumes between two songs while
keeping them perfectly in beat with one another. If done properly, the audience will never
have to stop dancing as the beat of one song will blend in with the beat of the new song—
sounding like one single song. DJs will do this for hours at a time, creating one gigantic
non-stop mix from the individual songs they have in their collection. Proper execution
of this technique requires the mastery of two tasks: matching tempo and matching phase.
Automatic Tempo and Phase Detection
As mentioned before, tempo is the measurement of speed of a song expressed as BPM.
Torq automatically determines the tempo of a song when you load it onto a Deck, so
matching tempos is as simple as moving the Speed slider on a Deck until the BPM Display
shows the same value as the other Deck. If you’re using external vinyl or CD control, you
can adjust the speed of the song using the turntable’s or CD player’s pitch adjuster.
Once you have matched the tempos of two songs, you need to start both songs at precisely
the right moment, or in-phase with each other. Phase refers to the starting point within
a cycle. In terms of music, it refers to where the beats are located in a song, such as the
downbeat of a measure. When beat-matching songs, you’ll normally want the downbeats
of both songs aligned with each other. When aligned properly, the beats of both songs
will blend together into one larger beat. If the songs are misaligned or out-of-phase, it will
sound terrible as the beats of the two songs will be playing at different times (in DJ jargon,
this is known as a “train wreck” and is something that should be avoided at all times).
Torq’s Scrolling Waveforms will help you match the phases of the two songs. Not only
can you visually align the transients in the waveforms, you can also use the Phase Grid for
automatic synchronization.
Phase Grid Manipulations
Torq also places a Phase Grid over the Scrolling Waveforms to help you see where the
beats are, even during a breakdown or rhythmless intro of a song. In order for Torq’s
automatic synchronization to work, the Phase Grid will need to be aligned properly with
the music. With the Phase Grids of both songs aligned properly, Torq will be able to
sync the two songs together without creating train wrecks. Torq will attempt to place
the Phase Grid in the proper location during song analysis. If Torq positions the Grid
incorrectly, it will be up to you to re-align it to the proper beat.