Filter
Top Products
Torq User Guide » Chapter 1
66
Torq User Guide » Chapter 13
66
< Tweak Knob
This knob controls the Reverb time. When fully counterclockwise, the Reverb will be extremely short, similar to
the sound heard in a small shower stall. As you turn this knob clockwise, the Reverb will become longer until it
sounds similar to a huge cathedral.
< Tweak Button
Pressing this button will “freeze” the Reverb. When activated, the Reverb will stop accepting audio input from
the Deck and will feed back on itself instead. The result is a reverb that “hangs” or “stalls” indenitely. When you
turn Freeze off, the Reverb will begin accepting input signals again, and the current “frozen” reverb will fade away
following the current Reverb Time. This can be another interesting way to ll up space during a break or to add
emphasis to a hit in the song.
Flanger
A Flanger is a common effect found in most effect processors. Flanging grew from a studio trick where engineers would play
identical material on two tape decks, then make slight changes to the play speed of the two tape machines by dragging their
hand on the anges of the tape reels. The result is a “wooshing” sound that can be compared to a jet yover.
< Enable Button
Naturally, this button turns the Flanger on and off.
< Mix Knob and Routing Button
Unlike the two effects discussed so far, the Flanger works best with the Routing button set to Insert mode. This
allows you to completely replace the original audio signal with the anged version (by turning this knob fully
clockwise) in order to emphasize the effect. Note: The effect will still work in Send mode, but it will be less
pronounced.
< Tweak Knob and Button
The function of the Flanger’s Tweak knob is determined by the state of the Tweak button:
» When the Tweak button is off, the Flanger will be in Manual mode. The Tweak knob will then control the
delay time of the Flanger. When the knob is counterclockwise, the Flange effect will be very tight. As the
knob is turned clockwise, the effect will become more dramatic and metallic in nature.
» If the Tweak button is on, the Flanger will be in Automatic mode. In this mode, the delay time for the Flanger
will be adjusted automatically. The Tweak knob will then set the rate of the automatic adjustment—turning
the knob clockwise will increase the modulation rate.