Filter
Top Products
26
Getting Ready
Getting Ready
Restoring the Factory Settings
(Factory Reset)
When using the RD-700 for the first time, start by returning the settings to
their factory defaults so that the RD-700 operates as described in the
procedures in the owner’s manual.
fig.panel
1
Press [EDIT], getting the indicator to light.
The Edit Menu screen appears.
fig.Editmenu2.eps_150
2
Press CURSOR [ ] to select “9.Utility.”
3
Press CURSOR [ ] to display the Edit screen.
NOTE
Executing this operation
deletes the Setup settings
(p. 54). If you want to keep
any internally stored
content, use the “Bulk
Dump (Bulk Dump
SETUP)” procedure to save
the data to an external
sequencer (p. 92).
Notes
Never turn off the power during Factory Reset (while “Now,
Executing” appears in the display).
Turning off the power while Factory Reset is in progress may result in
corrupted internal data and may prevent the power from being turned on
again. If you have confirmed that the internal data has been lost, or if a
similar problem exists, consult the retailer from whom you purchased the
instrument, or the nearest Roland Service Center. Note, however, that
Roland assumes no liability, including compensation, for consequences
arising from any loss of data.
CONTROL
12,4 6,7 3,5
RD-700_e.book 26 ページ ２００４年４月２６日 月曜日 午前１１時５４分