Filter
Top Products
74
Detailed Settings for Each Function ([EDIT])
Edit Mode
Changing the [CONTROL] Knob
Settings (Control/Src)
Normally, the [CONTROL] knob is used for making settings
that adjust the multi-effects (MFX Control), but they can also
be used for settings that change the way tones are played or
the tempo.
NOTE
When TONE CONTROL is assigned to Control, you cannot
change the parameters affected by the [CONTROL] knob.
The parameters that are changed are predetermined for each
individual Tone.
Additionally, effects may not be applied to some Tones (for
example GM Tones).
When Control is set to TONE CONTROL, turning the
[CONTROL] knob changes the way the tone is played,
regardless of whether MULTIEFFECT [ON/OFF] is switched
on or off.
Changing the Equalizer
Frequency Settings (Freq/Q)
This changes the EQUALIZER knob frequency settings.
NOTE
With the System’s EQ Control set to SYSTEM (p. 70), you
cannot change the above parameters. “---” appears in the
screen.
Parameter Value Description
Control
OFF
MFX CONTROL
The [CONTROL] knob
adjusts the amount of
multi-effect applied.
TONE CONTROL
The [CONTROL] knob
changes the way tones
are played.
TEMPO
CONTROL
The [CONTROL] knob
changes the tempo.
Src
CC1–CC31,
CC33–CC95,
96: PITCH BEND,
97:
AFTER TOUCH
This setting deter-
mines the MIDI mes-
sages that will be used
for transmitting the
settings of the [CON-
TROL] knob. MIDI
messages are not
transmitted when
TEMPO CONTROL is
selected for the Con-
trol.
Parameter
Value Description
EQ Low
Freq
200, 400 Hz
Selects the frequency
for the low-frequency
equalizer. This general-
ly changes the level of
the frequency range ex-
tending below this
point.
EQ Mid
Freq
200, 250, 315, 400,
500, 630, 1000,
1250, 1600, 2000,
2500, 3150, 4000,
5000, 6300, 8000
Hz
Set Frequency Point for
the mid-frequency
equalizer. Changes the
level of the selected fre-
quency range, with fre-
quency selected here at
the center.
EQ Mid-Q
0.5, 1.0, 2.0, 4.0,
8.0
Adjusts the “Q” (band-
width) of mid-frequen-
cy equalization. The
higher the value, the
narrower the range of
frequencies that are af-
fected.
EQ High
Freq
2000, 4000, 8000
Hz
Selects the frequency
for the low-frequency
equalizer. This general-
ly changes the level of
the frequency range ex-
tending above this
point.
<Band>
LOW, MID,
HIGH
Selects the frequency
range for the Gain set-
ting. Corresponds to
the LOW, MID, and
HIGH EQUALIZER
knobs.
Gain
-12.0–+12.0 dB
(0.2 dB steps)
The gain of the range
determined by <Band>
can be changed. You
can also change this
value by turning the
[EQUALIZER] knob.
RD-700_e.book 74 ページ ２００４年４月２６日 月曜日 午前１１時５４分