Filter
Top Products
39
Performing with the Keyboard
Performing
Selecting Wave Expansion Board Tones
Up to two optional wave expansion boards (SRX series) can be installed into
the RD-700.
Use the following procedure when selecting tones stored on an wave
expansion board.
fig.panel
1
Press ONE TOUCH [PIANO].
This selects a single tone to be played over the entire keyboard.
2
Press EXPANSION [A] or [B] to make its indicator light.
fig.LCD
If you hold down
EXPANSION [A] or [B] for several seconds, the
name of the installed wave expansion board appears in the
display (
p. 18
).
3
Press [NUM LOCK] to turn on the button indicator.
4
Press [INC/YES] or [DEC/NO], or press the TONE SELECT
buttons to select the Tone.
When using the TONE SELECT buttons to input Tone numbers, press
[ENTER] afterwards to set the number.
5
Play the keyboard, and you will hear the selected tone.
For instructions on
installing the Expansion
Board, refer to “Installing
the Wave Expansion
Board” (p. 15).
CONTROL
142 3
For details on the Tone list
for Wave Expansion Board,
refer to the “Patch List”
and the “Rhythm Set List”
of the owner’s manual for
the SRX Series.
When changing tones in
Layer or Split mode, select
the part for which the tone
is to be changed with the
PART SELECT buttons,
without pressing the ONE
TOUCH [PIANO] button.
For details, refer to
“Changing Tones in
Layer and Split Mode” (p.
44).
RD-700_e.book 39 ページ ２００４年４月２６日 月曜日 午前１１時５４分