1-8
<device> system-view
[device] interface GigabitEthernet 1/0/1
[device-GigabitEthernet1/0/1] shutdown
[device-GigabitEthernet1/0/1]
%Apr 2 08:11:14:220 2000 device L2INF/5/PORT LINK STATUS CHANGE:- 1 -
GigabitEthernet1/0/1 is DOWN
[device-GigabitEthernet1/0/1] undo shutdown
[device-GigabitEthernet1/0/1]
%Apr 2 08:11:32:253 2000 device L2INF/5/PORT LINK STATUS CHANGE:- 1 -
GigabitEthernet1/0/1 is UP
# Disable GigabitEthernet 1/0/1 from outputting Up/Down log information, execute the shutdown
command or the undo shutdown command on GigabitEthernet 1/0/1, and no Up/Down log information
is output for GigabitEthernet 1/0/1.
[device-GigabitEthernet1/0/1] undo enable log updown
[device-GigabitEthernet1/0/1] shutdown
[device-GigabitEthernet1/0/1] undo shutdown
Copying Port Configuration to Other Ports
To make some other ports have the same configuration as that of a specific port, you can copy the
configuration of the specific port to the ports.
Specifically, the following types of port configuration can be copied from one port to other ports: VLAN
configuration, protocol-based VLAN configuration, LACP configuration, QoS configuration, GARP
configuration, STP configuration and initial port configuration. For the detailed copy content, please
refer to the Command Manual.
Follow these steps to copy port configuration to other ports:
To do… Use the command… Remarks
Enter system view
system-view
—
Copy port configuration
to other ports
copy configuration source { interface-type
interface-number | aggregation-group
source-agg-id } destination { interface-list
[ aggregation-group destination-agg-id ] |
aggregation-group destination-agg-id }
Required
z If you specify the source aggregation group ID, the system uses the port with the smallest port
number in the aggregation group as the source.
z If you specify the destination aggregation ID, the configuration of the source port will be copied to
all ports in the aggregation group.
Configuring a Port Group
To make the configuration task easier for users, certain devices allow users to configure on a single port
as well as on multiple ports in a port group. In port group view, the user only needs to input the
