1-22
HTTP Test
Network requirements
As shown in Figure 1-5, Switch serves as the HWPing client, and a PC serves as the HTTP server.
Perform a HWPing HTTP test between Switch and the HTTP server to test the connectivity and the time
required to download a file from the HTTP server after the connection to the server is established.
Figure 1-5 Network diagram for the HTTP test
Switch
HWPing Client
IP network
10.1.1.1/8 10.2.2.2/8
HTTP Server
Configuration procedure
z Configure HTTP Server:
Use Windows 2003 Server as the HTTP server. For HTTP server configuration, refer to the related
instruction on Windows 2003 Server configuration.
z Configure HWPing Client (Switch):
# Enable the HWPing client.
<device> system-view
[device] hwping-agent enable
# Create a HWPing test group, setting the administrator name to "administrator" and test tag to "HTTP".
[device] Hwping administrator http
# Configure the test type as http.
[device-hwping-administrator-http] test-type http
# Configure the IP address of the HTTP server as 10.2.2.2.
[device-hwping-administrator-http] destination-ip 10.2.2.2
# Configure to make 10 probes per test.
[device-hwping-administrator-http] count 10
# Set the probe timeout time to 30 seconds.
[device-hwping-administrator-http] timeout 30
# Start the test.
[device-hwping-administrator-http] test-enable
# Display test results
[device-hwping-administrator-http] display hwping results administrator http
HWPing entry(admin administrator, tag http) test result:
Destination ip address:10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 47/87/74
Square-Sum of Round Trip Time: 57044
Last succeeded test time: 2000-4-2 20:41:50.4
Extend result:
