1-29
To do… Use the command… Remarks
Enter system view
system-view
—
Enable MSTP
stp enable
Required
MSTP is disabled by default.
Enter Ethernet port view
interface interface-type
interface-number
—
Disable MSTP on the
port
stp disable
Optional
By default, MSTP is enabled on all ports after
you enable MSTP in system view.
To enable a device to operate more flexibly,
you can disable MSTP on specific ports. As
MSTP-disabled ports do not participate in
spanning tree calculation, this operation saves
CPU resources of the device.
You are not recommended to enable MSTP on GigabitEthernet 1/0/29 on the switching engine of the
WX3024, GigabitEthernet 1/0/11 on the switching engine of the WX3010 or GigabitEthernet 1/0/9 on
the switching engine of the WX3008.
Other MSTP-related settings can take effect only after MSTP is enabled on the device.
Configuration example
# Enable MSTP on the device and disable MSTP on GigabitEthernet 1/0/1.
1) Perform this configuration in system view
<device> system-view
[device] stp enable
[device] stp interface GigabitEthernet1/0/1 disable
2) Perform this configuration in Ethernet port view
<device> system-view
[device] stp enable
[device] interface GigabitEthernet1/0/1
[device-GigabitEthernet1/0/1] stp disable
Configuring Leaf Nodes
Complete the following tasks to configure a leaf node:
Task Remarks
Enabling MSTP
Required
To prevent network topology jitter caused by other
related configurations, you are recommended to
enable MSTP after performing other configurations.
Configuring an MST Region Required
