1-29
Index Response Status LastRC Time
1 4 1 0 2000-04-02 08:26:02.9
2 5 1 0 2000-04-02 08:26:02.8
3 4 1 0 2000-04-02 08:26:02.8
4 5 1 0 2000-04-02 08:26:02.7
5 4 1 0 2000-04-02 08:26:02.7
6 5 1 0 2000-04-02 08:26:02.6
7 6 1 0 2000-04-02 08:26:02.6
8 7 1 0 2000-04-02 08:26:02.5
9 5 1 0 2000-04-02 08:26:02.5
10 7 1 0 2000-04-02 08:26:02.4
For detailed output description, see the corresponding command manual.
UDP Test (Udpprivate Test) on the Specified Ports
Network requirements
Both the HWPing client and the HWPing server are WX3000 series devices. Perform a HWPing
Udpprivate test on the specified ports between the two devices to test the RTT of UDP packets between
this end (HWPing client) and the specified destination end (HWPing server), with the port number set to
8000.
Network diagram
Figure 1-9 Network diagram for the Udpprivate test
Switch A
Switch B
HWPing Client
IP network
10.1.1.1/8 10.2.2.2/8
HWPing Server
Configuration procedure
z Configure HWPing Server (Switch B):
# Enable the HWPing server and configure the IP address and port to listen on.
<device> system-view
[device] hwping-server enable
[device] hwping-server udpecho 10.2.2.2 8000
z Configure HWPing Client (Switch A):
# Enable the HWPing client.
<device> system-view
[device] hwping-agent enable
# Create a HWPing test group, setting the administrator name to "administrator" and test tag to
"udpprivate".
[device] Hwping administrator udpprivate
# Configure the test type as udpprivate.
[device-hwping-administrator-udpprivate] test-type udpprivate
# Configure the IP address of the HWPing server as 10.2.2.2.
