Fostex VR800 Musical Instrument User Manual


 
15
VR800 Owner’s Manual (Names and Functions)
7. AC IN connector
The power cable packaged with this recorder ia connected
here.
8. Power switch [POWER]
This switch turns power on and off to the VR800.
Note:
Always plug the power cable to the recorder before
plugging the cable into the wall outlet.
MIDI
IN
PUNCH
IN/OUT
Refer to page 40 for more information on using the PUNCH
IN/OUT jack.
1. Punch in/out jack [PUNCH IN/OUT] (Connector: phone)
Using an optional foot switch connected to this jack enables
you to perform the manual punch In/Out operation
(including rehearsal) using your foot. Connect an optional
Fostex foot switch, Model 8051.
Refer to page 68 for more information on using the MIDI IN
jack.
5. MIDI IN jack [MIDI IN] (Connector: DIN 5-pin)
Connect this jack to the MIDI OUT jack of an external MIDI
device. You can control the VR800 remotely by inputting
MMC (MIDI Machine Control) command or FEX (Fostex
System Exclusive Message) here.
Side Panel
P
U
N
C
H
IN
/O
U
T
1
6. Word Out jack [WORD OUT] (Connector: BNC)
Word clock signal from the VR800 is output here.
This jack and WORD IN of the external digital equipment
must be connected if the WORD IN connector ia provided
in the external digital equipment (digital mixer, etc.) which
is connected to the VR800.
Refer to the separate “Quick Operation Guide” for operating
procedures.
Note:
Be sure to use an “unlatch type” foot switch if you
use a foot switch other than the Model 8051. Otherwise, a
malfunction could occur.