Filter
Top Products
57
VR800 Owner’s Manual (Cue & Review Function)
Cue & Review Function
6. Press the PLAY button to restore the original
playback speed.
This chapter explains how to use the “Cue & Review” function with the REWIND button, the F FWD button, and
the SHUTTLE function, and also explains “Digital Scrubbing” with the scrub mode function. During Cue/Review
and Digital Scrubbing you will hear the sound recorded on the disk, which makes it easy for you to swiftly locate
the desired point without failure while listening to the sounds.
4. Press the PLAY button again to restore the original
play back speed.
Cue & Review function using the REWIND and F FWD buttons
You may cue & review the audio data at three-times speed while the recorder is playing.
The prerequisite of the following operation is that the time base is ABS, however, the operation can be executed in any time
base. To execute this function with a non-ABS time base there is a need to priory switch over to the desired time base.
1. Press the PLAY button to play the audio data.
Cue & Review function using the SHUTTLE feature
You can use the SHUTTLE mode for 1-time~64-times Cue/Review while playing back the recorder section.
4. Release the SHIFT key to cancel the cue and review
operation.
The VR800 resumes playback at the original speed.
1. Press the PLAY button to start playback.
3. Adjust the monitor sound of the track to monitor
on the mixer.
2. Press the F FWD button during playback.
[FWD>] appears on the display, and the VR800 cues in
the forward direction at three-times speed.
5. Press the REWIND button instead of the F FWD
button.
[<RWD] appears on the display, and the VR800 cues in
the reverse direction at three-times speed.
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
44.1kHz
SMF
ABS
DIGITAL
PGM
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
44.1kHz
SMF
PGM
ABS
DIGITAL
3. Adjust the monitor sound of the track to monitor
on the mixer.
2. Hold down the SHIFT key and turn the JOG dial
clockwise or counter-clockwise.
Turning the JOG dial clockwise qqwill change the cueing
speed. Turning the JOG dial counter-clockwise will change
the reviewing speed.
The VR800 displays the selected cue or review speed,
which you can select from normal, two-times, four-times,
eight-times, 16-times, 32-times, and 64-times speed.
As long as you are holding down the SHIFT key, playback
continues at the selected speed.
Note: The cue and review operation does not affect pitch.
Because the VR800 performs this function by skipping
part of data during playback.
Note: When the beginning of the disk is reached during
the review operation, the VR800 starts qnormal playback,
even if you are still holding down the SHIFT key. When
the end of the disk (ABS time: 23H 59M 59S) is reached
during the cue operation, the VR800 stops and the PLAY
button lamp flashes.
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
44.1kHz
SMF
ABS
DIGITAL
PGM
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
44.1kHz
SMF
ABS
DIGITAL
PGM
Display of 16-times review
Display of 32-times cue