Filter
Top Products
81
VR800 Owner’s Manual (Saving and Loading Song Data)
Since there is only one Program in the destination disk in
this example, you can select only [P01].
If the destination disk contains multiple Programs, see
the following <Memo>.
6. Use the JOG dial to select the load destination
Program and press the EXECUTE/YES key.
The VR800 starts loading data.
Backup data [B01] is loaded to Program [P01] on the cur
rent disk. As the operation progresses, the REMAIN value
counts down.
When the load operation is completed, [COMPLETED !]
lights up.
7. Press the EXIT/NO key to exit SETUP mode.
The Time Base display of the loaded Program appears.
8. Press the EJECT button on the backup drive to eject
the backup disk.
<Memo>
If you saved one Program to multiple backup disks, the
VR800 indicates that the disk in the drive is the “first”
disk, as follows:
Confirm that this message appears, and execute the load
operation. When data in the first disk is loaded, the VR800
automatically ejects the disk and displays [Inst. Disk 2],
meaning “Please insert the second disk.” Insert the sec-
ond disk and continue the load operation.
Note:
Make sure that you insert the disks in the correct
order. If you insert the wrong disk, the VR800 displays
[Wrong disk] and ejects the disk. Follow the disk markings
you made during the save operation.
<Memo>
If the load destination disk contains multiple Programs,
the VR800 asks whether you wish to set up a new Pro-
gram in Step 6 of the procedure above. ([03] and [SURE ?]
flash.) This is because the existing Programs may already
contain data. If you do not mind overwriting the existing
data with the loaded data, select the desired Program
number as the load destination.
In the above display example, the VR800 asks you if you wish
to create a new Program 3, since Programs 1 and 2 on the
current drive disk contain data.
Lights up
Flashing
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
REMAIN
SETUP
MB
44.1kHz
DIGITAL
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
44.1kHz
COMPLETED !
DIGITAL
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
44.1kHz
DIGITAL
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
SETUP
?
SURE
44.1kHz
DIGITAL
Saving/loading via a DAT or adat
To use a DAT or adat to save and load data, the current SCSI drive disk should be a fixed disk that is formatted in
“Master 8ch mode.” However, save/load only when using DAT is possible, and can also be used for the “Master
4ch mode disk.”
Refer to the “Saving/loading data using an 3.5-inch E-IDE hard disk as the current drive” section for a detailed
procedure of the save/load operation.