Filter
Top Products
93
VR800 Owner’s Manual (Changing the initial setting: SETUP mode)
Tempo Map
Time signature setting
Tempo setting
001 BAR 4 4
005 BAR 3
4
001 BAR 1
TEMPO 120
003 BAR 1
TEMPO 90
005 BAR 3
TEMPO 60
007 BAR 2
TEMPO 120
5. Press the EXECUTE/YES key.
The display shows the stored bar/beat/tempo, then
returns to the Tempo Edit indication (as shown in step
4).
6. Repeat steps 3-5 to store necessary tempo data.
For example, if you specify tempo values in the song with
[001 BAR 4 4] and [005 BAR 3 4] settings, the Tempo
Map includes the settings shown in the table below.
Modifying (or deleting) stored tempo settings
1. Repeat steps 1-3 described in the “Storing a tempo
value” section to display [Tempo Edit ?].
2. Press the HOLD/> key, the REWIND button, or the
F FWD button so that the flashing cursor is on the
measure number. Turn the JOG dial to select bar/
beat to edit or delete.
3. Press the HOLD/> key, the REWIND button, or the
F FWD button so that the flashing cursor is on the
TEMPO number.
4. Use the JOG dial to enter a new value.
Entering [---] deletes the data at the selected bar/beat.
5. Press the EXECUTE/YES key.
6. Press the STOP button or the EXIT/NO key
repeatedly to exit SETUP mode.
Setting the Metronome function (“Click ?” menu)
“Setting the Metronome function” menu allows you to determine whether or not the VR800 outputs a metronome
sound from Real track 8 during playback or recording. Turning the Metronome function on enables you to
record your performance while playing the instrument accompanying the metronome sound.
Note:
Since Real track 8 outputs the metronome sound when this function is turned on, you cannot play the audio recorded on this track.
Also, do not record any data on track 8.
The VR800 can output the metronome sound even from an unrecorded area (outside of the range from ABS 0 to REC END) on track 8.
Setting the Metronome function
1. While the VR800 is stopped, press the SETUP key
to enter SETUP mode.
2. Turn the JOG dial to select [Click ?] ([?] flashes.),
then press the EXECUTE/YES key.
The current setting ([oFF] or [on]) appears on the display.
Pressing the EXECUTE/YES key lights up the flashing [?]
character steadily; the current setting flashes. The initial
setting is [oFF] as shown below.
4
4
4
3
Tempo=120
Tempo=90
Tempo=60
Tempo=120
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
44.1kHz
DIGITAL
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
44.1kHz
DIGITAL
• Initial setting : [oFF]
• Option : [oFF], or [on]
* You can turn the function on and off for each Program individually.
* The settings cannot be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the unit.
flashes
flashes