Filter
Top Products
VR800 Owner’s Manual (Storing a Locate Point <Edit Point>)
49
1
4
3
Storing and editing the locate points to the memory keys
• Select the desired Time Base using the TIME BASE SEL key an if you wish to use a Time Base other ABS.
• The stored or edited locate points are used only in the currently-selected Program.
Storing in real-time
You can store the locate point (in the ABS, MTC, or BAR/BEAT/CLK Time Base) in real-time while the VR800 is
playing.
• You can omit Step 2 to speed operation.
• If you set “BAR/BEAT Resolution mode” in SETUP mode
to ON, the VR800 will round off the CLK value of the captured
bar/beat/clock value. That is, the locate point will be at the
beginning of the beat (00). Refer to page 103 for more
information.
2
1. Press the PLAY button to play back data.
2. When the point you wish to store is reached, press
the HOLD/> key.
The time value or bar/beat/clock value of the point is
captured. The VR800 enters data edit mode.
3. Press the STORE key.
The STORE key lamp lights up.
4. Press the desired memory key.
The STORE key lamp turns off.
The captured time value (or bar/beat/clock value) is
stored in the memory key. After the data is stored, the
VR800 displays the previous Time Base and continues
playback.
Flashing
Note: The following menu (##=number from 00-99)
appears when pressing the STORE key. This menu is
used to store data in the LOCATE ley, described later.
Ignore this menu and go to the next step when storing
data in the memory key.
Flashing
5. Press the STOP button.
SHIFT P.EDIT
LOC MEM
RECORD
STOP
PLAY REW F FWD
AUTO PUNCH
CLIPBOARD
AUTO RTN
OUTIN
ENDOUTINSTART
EJECT
ACCESS
5678
OL
24
12
6
0
1234
RECORD TRACK
4321 5
678
EXECUTE
/ YES
EXIT
/ NO
DISP SEL
UNDO / REDO
EDITHOLD/
STORE
SETUP
JOG
VARI PITCH SCRUBLOCATEAUTO PLAY
PGM SEL
AUTO RTN
TIME BASE SEL
SHUTTLE
LOCATE REC END
LOCATE ABS 0
CLIPBOARD PLAY
PUNCH
AUTO
OPTICAL
A SYNC
PREVIEW
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
LOC SMFSF
DIGITAL
ABS
44.1kHz
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
DIGITAL
44.1kHz