Filter
Top Products
VR800 Owner’s Manual (Storing a Locate Point <Edit Point>)
52
4. Select the LOCATE number desired using the JOG
dial.
LOCATE number from 00-99 are selectable. However,
select a number other then 00.
6. After completing the store process, press the STOP
button to stop the recorder section.
• You can omit Step 2 to speed operation.
• If you set “BAR/BEAT Resolution mode” in SETUP mode
to ON, the VR800 will round off the CLK value of the captured
bar/beat/clock value. That is, the locate point will be at the
beginning of the beat (00). Refer to page 103 for more
information.
Editing and storing locate data
If you know the position of the desired locate point, follow the steps below.
1. Press the HOLD/> key while the VR800 is stopped.
The currently-displayed time value (or bar/beat/clock value)
is captured and the VR800 enters data edit mode.
1. Press the PLAY button to start playback.
2. Press the HOLD/> key in the store location.
When you press the HOLD/> key the time base (or bar/
beat/clock) will return to the edit mode of the data put
on hold.
3. Press the STORE key. (the STORE key lamp lights up)
The memory number selection menu will appear, as
follows.
5. Next press the LOCATE key.
The time base (or bar/beat/clock) put on hold is stored
as data in the LOCATE number selected. The system will
return to the original time base when the storage process
is completed, and playback is resumed.
Flashing
Flashing
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
LOC SMFSF
DIGITAL
ABS
44.1kHz
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
DIGITAL
44.1kHz
2, 4
3
1, 2
SHIFT P.EDIT
LOC MEM
RECORD
STOP
PLAY REW F FWD
AUTO PUNCH
CLIPBOARD
AUTO RTN
OUTIN
ENDOUTINSTART
EJECT
ACCESS
5678
OL
24
12
6
0
1234
RECORD TRACK
4321 5
678
EXECUTE
/ YES
EXIT
/ NO
DISP SEL
UNDO / REDO
EDITHOLD/
STORE
SETUP
JOG
VARI PITCH SCRUBLOCATEAUTO PLAY
PGM SEL
AUTO RTN
TIME BASE SEL
SHUTTLE
LOCATE REC END
LOCATE ABS 0
CLIPBOARD PLAY
PUNCH
AUTO
OPTICAL
A SYNC
PREVIEW
2
5
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
LOC SMFSF
DIGITAL
ABS
44.1kHz
Flashing