Filter
Top Products
VR800 Owner’s Manual (Storing a Locate Point <Edit Point>)
50
Editing and storing locate data
If you know the position of the desired locate point, follow the steps below.
Editing and storing data
You can recall data stored in the memory key, edit it, and store it. again
1. Press the HOLD/> key while the VR800 is stopped.
The currently-displayed time value (or bar/beat/clock value)
is captured and the VR800 enters data edit mode.
4. Press the desired memory key.
The STORE key lamp will turn off.
The input time value (or bar/beat/clock value) is stored
in the corresponding memory key.
3. Press the STORE key.
The [Press LOC:] menu will appear as indicated before.
Ignore this go to the next step.
4. Press the memory key that you pressed in Step 1
again.
The STORE key lamp will turn off. The edited data is
stored, and the VR800 displays the previous Time Base
indication.
1. While the VR800 is stopped, press the memory key
that stores the data you wish to edit.
The stored data appears on the display and the VR800
enters data edit mode.
2. Press the HOLD/> key, REWIND button, or the F FWD
button to move the flashing cursor on the time value
digit, and use the JOG dial to increase or decrease the
value.
2
4
3
1, 2
SHIFT P.EDIT
LOC MEM
RECORD
STOP
PLAY REW F FWD
AUTO PUNCH
CLIPBOARD
AUTO RTN
OUTIN
ENDOUTINSTART
EJECT
ACCESS
5678
OL
24
12
6
0
1234
RECORD TRACK
4321 5
678
EXECUTE
/ YES
EXIT
/ NO
DISP SEL
UNDO / REDO
EDITHOLD/
STORE
SETUP
JOG
VARI PITCH SCRUBLOCATEAUTO PLAY
PGM SEL
AUTO RTN
TIME BASE SEL
SHUTTLE
LOCATE REC END
LOCATE ABS 0
CLIPBOARD PLAY
PUNCH
AUTO
OPTICAL
A SYNC
PREVIEW
3. Press the STORE key.
The [Press LOC:] menu will appear as indicated before.
Ignore this go to the next step.
2. Press the HOLD/> key, REWIND button, or the F FWD
button to move the flashing cursor on the time value
digit, and use the JOG dial to increase or decrease the
value.
2
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
LOC SMFSF
DIGITAL
ABS
44.1kHz
Flashing
Flashing
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
DIGITAL
44.1kHz