Filter
Top Products
141
COSM AMP Chapter 9 Parameters Guide
Chapter 9
JC CLEAN / TW CLEAN / CRUNCH /
COMBO / BG LEAD / MS STACK /
R-FIRE / T-AMP / HI-GAIN / METAL
*1
The BRIGHT parameter setting is only partially available with
some JC CLEAN, CRUNCH, or BASS AMP settings in PREAMP
TYPE.
Type
Explanation
METAL (p. 141)
5150 DRIVE
This models the lead channel of a Peavey
EVH 5150.
METAL STACK This is a drive sound suited to metal.
METAL LEAD This is a lead sound suited to metal.
CUSTOM (p. 143)
CUSTOM
Custom amp
BASS AMP (p. 144)
VINTAGE
Models the Ampeg B-15.
MODERN Models the SWR SM-400.
Parameter/
Range
Explanation
GAIN
0–120
Adjusts the distortion of the amp.
BASS
0–100
Adjusts the tone for the low frequency
range.
MIDDLE
0–100
Adjusts the tone for the middle frequency
range.
TREBLE
0–100
Adjusts the tone for the high frequency
range.
PRESENCE
0–100
Adjusts the tone for the ultra high frequency
range.
LEVEL
0–100
Adjusts the volume of the entire preamp.
* Be careful not to raise the Level setting too
high.
BRIGHT
Turns the bright setting on/off. *1
OFF Bright is not used.
ON Bright is switched on to create a lighter and
crisper tone.
GAIN SW
LOW, MIDDLE, HIGH
Provides for selection from three levels of
distortion: LOW, MIDDLE, and HIGH. Dis-
tortion will successively increase for set-
tings of LOW, MIDDLE and HIGH.
* The sound of each Type is created on the basis
that the Gain is set to MIDDLE. So,
normally set it to MIDDLE.
SOLO SW
OFF, ON Pressing [SOLO] switches the tone to one
suitable for solos.
SOLO LEVEL
0–100
Adjusts the volume level when the Solo
switch is ON.
VG-99_e.book 141 ページ ２００７年７月５日 木曜日 午前９時２２分