Filter
Top Products
51
Chapter 4 Global Device Settings (SYSTEM)
Chapter 4
The text and icons in the LCD screen may be difficult to make out
sometimes, such as immediately after the VG-99 is turned on or after
extended use. The conditions at the place where you are using the
VG-99 can also affect visibility. Should you run into this problem, try
adjusting the contrast.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to display Page 1.
3.
Press [F1] (LCD).
4.
Turn the F1 knob to adjust the contrast.
This sets the signals and levels output for each of the VG-99’s output
jacks and connectors (MAIN OUT, SUB OUT, and DIGITAL OUT).
1.
Press [SYSTEM].
2.
Press PAGE [ ] [ ] to display Page 2.
3.
Press [F1] (OUTPUT).
4.
Set the OUTPUT MODE parameter to SYSTEM
with [F1] (SELECT) or with the F1 knob.
* If set to PATCH, the values set under
“Setting the Output Signal
and Level (OUTPUT)”
(p. 37) are enabled. The value in the
MIXER screen is disregarded, and instead the value < > is applied.
5.
Set the signal and level output to each output
with PAGE [ ] [ ] or with the F1–F6 knobs.
For detailed information on the parameters that can be
set, refer to
“OUTPUT”
(p. 147).
Adjusting the Screen’s
Contrast
Setting the Output Signal
and Level (SYSTEM OUTPUT)
VG-99_e.book 51 ページ ２００７年７月５日 木曜日 午前９時２２分