Filter
Top Products
188
Chapter 10 Appendices
Unable to save SYSTEM/USB USB
IN settings
→
If the USB IN parameter is set to COSM GTR A, COSM
GTR B, or NORMAL PU, then MAIN & SUB will be set
the next time the VG-99 is powered up. If you plan to use
COSM GTR A, COSM GTR B, or NORMAL PU, remake
this setting each time you turn on the power to the VG-
99 (p. 173).
Patches not switching
❏
Is some screen other than the Play screen shown in the
display?
→
With the VG-99, you cannot switch patches in any screen
other than the Play screen. Press [EXIT] one or more
times to return to the Play screen (p. 19).
❏
Is [SYSTEM] - MISC - PATCH EXTENT set correctly?
→
The range of patches that can be selected is limited by
the PATCH EXTENT setting. Be sure to set this correctly.
Unable to control parameters set
with Assign as expected
❏
Are the effects switched off?
→
Check to make sure the effects incorporating the
parameters being controlled are on.
❏
Is the patch set to anything other than ASSIGNABLE
(PATCH) in [SYSTEM] - CONTROL ASSIGN?
→
Even with the patch’s [CONTROL ASSIGN] setting
made, the settings made in [SYSTEM] - CONTROL
ASSIGN are given priority.
To enable the settings in the patch, set the controllers
under [SYSTEM] - CONTROL ASSIGN to ASSIGNABLE
(PATCH).
❏
Are the MIDI channels matched?
→
When carrying out operations using MIDI, check to
confirm that both devices are set to the same MIDI
channel (p. 58).
❏
Are the controller numbers (CC#) matched?
→
Check to confirm that the controller numbers you are
using are the same (p. 62).
MIDI messages not being
transmitted/received
❏
Could there be a short in the MIDI cable?
→
Try replacing the MIDI cable.
❏
Are the VG-99 and the external MIDI device connected
properly?
→
Check the connection with the external MIDI device.
❏
Are the MIDI channels matched?
→
Check to confirm that both devices are set to the same
MIDI channel (p. 58).
❏
If you are transmitting from the VG-99, have the
settings for transmission been made?
→
Check the Program Change message transmission ON/
OFF setting (p. 60) and the settings for the controller
number to be transmitted (p. 62).
Other Problems
VG-99_e.book 188 ページ ２００７年７月５日 木曜日 午前９時２２分