Filter
Top Products
169
SYSTEM Chapter 9 Parameter Guide
Chapter 9
FC-300
PATCH LEVEL
DEC
Decreases the patch level.
✔
✔
AB BALANCE
toB
Increases the volume level in
Channel B in the balance be-
tween Channel A and Channel
B.
✔
✔
AB BALANCE
toA
Increases the volume level in
Channel A in the balance be-
tween Channel A and Channel
B.
✔
✔
FC-300
AMP CTL 1
Switches to the channel as-
signed for the guitar amp con-
nected the FC-300’s AMP
CONTROL1 jack.
✔
✔
FC-300
AMP CTL 2
Switches to the channel as-
signed for the guitar amp con-
nected the FC-300’s AMP
CONTROL2 jack.
✔
✔ ✔
CTL1-4, FC-300 EXP SW1/EXP SW2,
FC-300 CTL1, 2, 4, 6, 8
FC-300 EXP3/CTL3, EXP4/CTL5, EXP5/CTL7
GK S1, S2
GK VOL, EXP PEDAL, FC-300 EXP1/EXP2
Parameter
Explanation
Parameter/
Range
Explanation
SYS EX MODE (System Exclusive Mode)
This sets the FC-300’s control method.
ON When connected to the VG-99, the FC-300
automatically changes to System Exclusive
mode and operates in accordance with the
settings made with the VG-99. This is the
setting you should normally select.
You can control the FC-300 even
without matching the VG-99’s and FC-
300’s Device IDs.
OFF Select OFF when controlling the FC-300’s
with the FC-300 (manually).
BANK CHANGE
This sets the timing with which tones switch when patches are
changed with the FC-300.
IMMEDIATE The tone changes immediately when the
FC-300’s pedals are pressed.
WAIT NUM
Even after the FC-300’s pedals are
pressed, the tone does not change until the
NUMBER is set.
QUICK TUNER
This enables use of the FC-300’s number pedals to switch the Tuner
function on and off.
The Quick Tuner function is enabled only when the FC-300’s MODE
is set to SYS EX.
OFF The QUICK TUNER function is not opera-
tional.
ON The QUICK TUNER function is operational.
The TUNER function is alternately switched
on and off each time the currently selected
number pedal is pressed.
VG-99_e.book 169 ページ ２００７年７月５日 木曜日 午前９時２２分