Filter
Top Products
74
Chapter 7 Using the VG-99 Connected to a Computer Via USB
1.
Press [SYSTEM].
2.
Press PAGE [ ] [ ] to go to Page 2.
3.
Press [F2] (USB).
4.
Press PAGE [ ] to go to Page 2.
5.
Change the setting’s value with [F2] (SELECT),
[F3] (OFF/ON) or the F2, F3 knobs.
For more information on signal paths set by the Direct
Monitor parameter settings, refer to
“Signal Flow”
(p.
183).
6.
Press [EXIT] one or more times to return to the
Play screen.
Setting the Direct Monitor
Parameter/
Range
Explanation
MON CMD (Monitor Command)
This setting determines whether or not the command (the Direct
Monitor command) controlling the Direct Monitor (described later)
setting is enabled.
DISABL The Direct Monitor command is disabled,
maintaining the Direct Monitor mode set by
the VG-99.
ENABLE The Direct Monitor command is enabled, al-
lowing the Direct Monitor mode to be
switched from an external device.
DIRECT MON (Direct Monitor)
Switches the output of the VG-99 sound to the PHONES jack, MAIN
OUT jacks, or SUB OUT jacks.
OFF Set this to Off if transmitting audio data in-
ternally through a computer (Thru).
ON The VG-99 sound is output. Set this to On
when using the VG-99 as a standalone de-
vice, without connecting to a computer
(only USB IN input sound will be output if
this is set to Off).
* This setting cannot be saved. It is set to ON when the power is turned
on.
* If you are using the special driver, you can control DIRECT MON On/
Off from ASIO 2.0-compatible application.
Audio signal
DIRECT MON
MAIN or SUB
USB OUT USB IN
Audio OUT
Audio IN
VG-99 sound
Computer
Headphones
Guitar Amp
Mixer
VG-99_e.book 74 ページ ２００７年７月５日 木曜日 午前９時２２分