Filter
Top Products
99
Chapter 8 Other Functions
Chapter 8
By employing the separately available RAD-99 rack mount adaptor,
you can use the VG-99 in a rack-mounted configuration.
1.
Turn the VG-99 over and remove the screws
from the bottom panel.
2.
Attach the RAD-99 as shown in the figure,
using the screws removed in Step 1 or the
knob nuts included with the kit.
3.
Mount the VG-99 in the rack.
Use screws (in four places) to securely affix the unit to the rack.
* Use the screws included with the rack.
For instructions on how to assemble the RAD-99 and
adjust the angle of attachment, refer to the RAD-99
Setting Manual.
Using the VG-99 Mounted in
a Rack
928, 929
• Use the screws (M5 x 10) included with the VG-99 to
attach the RAD-99. Use of other screws may damage the
device internally or cause the unit to be inadequately
secured.
• When turning the unit over, place some newspapers,
magazines, or other such material under the four corners
or at both ends to prevent damage to the buttons, dials,
and other controls. Also, try to orient the unit so no
buttons or controls are damaged.
• When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
• When removing the screws, be sure to keep them out of
the reach of children to prevent smaller children from
accidentally swallowing them.
• Take care not to allow hands and fingers to become
pinched when attaching and removing the units.
VG-99_e.book 99 ページ ２００７年７月５日 木曜日 午前９時２２分