Filter
Top Products
42
Chapter 4 Global Device Settings (SYSTEM)
* The parameters described in this chapter are saved when the power is
turned off. There is no need to carry out the Write procedure (p. 38).
To ensure optimal conditions for producing sounds with the VG-99,
making the correct settings affecting the Divided pickup (the GK
settings) is required.
The VG-99 can store ten separate sets of GK settings. If you are
playing more than one guitar using the VG-99, you can store
separate settings for each one, allowing you to be ready in moments
with the necessary settings when the guitars are switched.
After you have finished inputting the various settings, press [EXIT]
one or more times to return to the Play screen.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to display Page 1.
3.
Press [F3] (GK) to display the GK SETTING
screen.
4.
Press PAGE [ ] to display Page 1.
5.
Press [F4] (SELECT) or turn the F4 knob to
select the GK setting (1–10).
This specifies the setting to be stored as the GK setting.
* Pressing [EXIT] at this point and returning to the Play screen
enables the selected GK setting.
* When PATCH is selected for the SETTING MODE parameter, the
GK settings specified in each patch take priority. For detailed
information, refer to
“Using Different Guitar Settings in Each
Patch (SET MODE)”
(p. 46).
The following section describes parameters
related to the GK settings.
After you have finished inputting the various settings, press [EXIT]
one or more times to return to the Play screen.
You can give names to each of the GK settings.
1.
Follow Steps 1–3 in “Selecting the Settings”
(p. 42) to display the GK SETTING screen.
2.
Press PAGE [ ] to display Page 1.
3.
Press [F6] (NAME).
4.
Set the name using PAGE [ ] [ ], [F1]–[F5],
and the PATCH/VALUE dial.
* Press [EXIT] one or more times to return to the previous screen.
Inputting the Divided Pickup
Settings
Selecting the Settings
Naming GK Settings (GK NAME)
Function Button
Explanation
[F1] (INSERT)
Insert a space at the cursor location.
[F2] (DELETE)
Delete a character. The characters that
follow get shifted to the left.
[F3] (SPACE) Input a space at the cursor location.
[F4] (A0!)
Switch between uppercase letters and
lowercase letters.
[F5] (A<=>a)
Switch between uppercase letters, low-
ercase letters, numbers, and characters.
VG-99_e.book 42 ページ ２００７年７月５日 木曜日 午前９時２２分