Filter
Top Products
13 – Specifications, etc.–Error messages, etc.
TASCAM 788 Digital PortaStudio 121
DRIVE NOT FOUND
You are trying to eject a non-removable disk.
Or, you are trying to play, write or finalize a CD,
or perform a backup or restore without a CD-R
drive being connected.
Check and make the appropriate connections
after turning off
the power to the 788 and the
external device.
EXT SYNC SELECTED
You are trying to play or record, or use the mas-
tering, master check or CD player function
while the 788 is slaved to external
synchronization.
Use the sync master to control the 788, or set
the 788 to internal sync and try again.
IN-OUT TOO SHORT
The interval between the IN and the OUT
points is too short for track editing, repeat play-
back or punch operations.
Make sure that the gap between the IN and
OUT points is at least 0.5 seconds long or at
least 10 sub-frames in the case of auto punch
operations.
NEED CD xx
CONTINUE [YES]
CANCELßßß[NO]
You are performing a backup to CD. The 788 is
letting you know how many CDs will be
required for the backup.
Press
YES
if you have enough discs and you
want to continue with the backup.
Or, press
NO
if you want to cancel the backup
operation (not enough discs).
INSERT NEXT CD
CONTINUE [YES]
CANCELßßß[NO]
You are performing a backup or a restore oper-
ation ,and the 788 is asking you for the next
disc in the set.
Insert a new disc (backup) or the next disc in
the set (restore).
Press
YES
when you have inserted the disc.
Or, press
NO
if you want to cancel thebackup
or restore operation.
INVALID CD!
REPLACE CD
PRESS [YES / NO]
You are attempting to record a song or songs to
CD, but the CD is finalized and cannot be used
for recording single tracks (or has already been
used for recording and cannot be used for
recording a song list).
This message also appears if you are attempt-
ing a restore operation from the wrong disc.
Press
YES
or
NO
to make this message go
away and stop the procedure.
Use an unfinalized disc if you want to record a
single song, or a blank disc to record a song
list.
If you are attempting a restore, make sure that
you have the correct discs ready.
LOW DISK SPACE
There is not much space on the current disk or
partition.
Delete unused songs and/or carry out a
DELETE UNUSED operation.
LOCATE MARKS FULL
Each song can have up to 999 location marks,
stored in “slots”. This message appears if the
number is exceeded.
Delete any unwanted marks and try again.
NO ARMED TRACKS
You are attempting to record with no tracks
armed.
Arm the tracks on which you want to record,
and try again.
NO DISK SPACE!!
There is no space remaining on the current disk
or partition.
Delete unused songs and/or carry out a
DELETE UNUSED operation.
NO PRE-MASTERED
ßßSONGS FOUND
PRESS [EXIT/NO]
You are trying to record songs on a CD-R, but
the current partition does not contain any songs
that have been pre-mastered.
Press
EXIT
/
NO
to make this message go
away and stop the CD recording procedure.
Follow the pre-mastering procedure for the
songs you want to record to CD.
It is also possible that you have selected a disk
or partition that does not contain the songs you
want to record. Check this, and re-select the
disk or partition if necessary.
Message Meaning Action