Filter
Top Products
Part VIII Sound Edit
112
QQTG0701
Sound Edit
4.
Select HIGH and use the
∧
and
∨
buttons and
select H-FADE and use the
∧
and
∨
buttons to
define the area of the higher range of tone out-
put.
• By entering different values for the H-FADE and HIGH
settings, you can define a sloping volume decrease from
the peak output which corresponds to the note pitch.
• By overlapping the L-FADE and H-FADE curves of each
different tone, you can achieve a cross-fade effect, where
the sound gradually changes in relation to pitch.
5.
Repeat steps 2 to 4 for the other tones, as
desired.
VELOCITY LAYER
Adjust these settings to regulate the tone output
relative to the velocity.
1.
Use the PAGE buttons to view the 3/4 display.
• The display looks similar to the following.
• Use the ▲ and ▼ buttons to select a setting item and
then the
∧
and
∨
buttons to specify a selection.
2.
Use the buttons to the left of the display to
select a tone (1st, 2nd, 3rd or 4th).
3.
Select L-FADE and use the
∧
and
∨
buttons
and select LOW and use the
∧
and
∨
buttons
to define the
pp
sound output area for the
lower range.
4.
Select HIGH and use the
∧
and
∨
buttons and
select H-FADE and use the
∧
and
∨
buttons to
define the
ff
sound output area for the higher
range.
• By overlapping the L-FADE and H-FADE curves of each
different tone, you can change the way the tone sounds
relative to how hard or softly the keyboard is played.
5.
Repeat steps 2 to 4 for the other tones, as
desired.
TONE DYNAMICS
You can adjust the settings so that a different
sound (tone) is output for each tone depending
on the velocity (how hard the keys are played).
1.
Use the PAGE buttons to view the 4/4 display.
• The display looks similar to the following.
2.
Use the buttons to the left of the display to
select a tone.
3.
Use the ▲ and ▼ buttons to select the column
for the function you wish to adjust.
4.
Select the tone waveform.
• Use the GR
∧
and
∨
buttons to select the sound group.
Use the TONE WAVEFORM
∧
and
∨
buttons to select
the waveform.
5.
Use the LEV
∧
and
∨
buttons to adjust the vol-
ume. Use the FLT
∧
and
∨
buttons to set the
sound.
6.
Use the VELOCITY
∧
and
∨
buttons to specify
the velocity range.
• When the upper limit of a waveform is set to 127, no
more waveforms can be added.
7.
Repeat steps 3 to 6 to edit the other wave-
forms, as desired.
8.
Repeat steps 2 to 7 for the other tones, as
desired.
13_Part VIII.fm 112 ページ ２００３年５月２０日 火曜日 午前８時２１分