Filter
Top Products
Part III Sequencer
67
QQTG0701
Sequencer
Ⅲ
ⅢⅢ
Ⅲ
Correcting the data
1.
In the STEP RECORD mode, specify the track
you wish to correct.
2.
Use the MEAS buttons to go to the measure
you wish to modify. Use the CURSOR buttons
to move the cursor to the point (
∗
) you wish
to edit.
• The data stored at that point is shown on the display.
• When multiple data is stored at one point, different data is
displayed in order each time a CURSOR button is
pressed. When a chord is recorded, a different note in the
chord is displayed each time a CURSOR button is
pressed.
3.
Correct the data.
There are three types of data:
Performance data
NOTE data (note pitch) and VEL data (how hard
the key was played) and LEN data (1 = 1/96 of a
quarter note [
q
]) are displayed. Use the relevant
buttons to correct the data as desired.
Sound data
The name of the sound is displayed. Change the
sound as desired (the sound setting display is
interposed on the current display).
Control data
The name of the function is displayed. Change
the data as desired.
• Press the ERS button to erase the data which is dis-
played.
• You can also correct data which was stored in the REAL-
TIME RECORD mode.
• Performance (NOTE) data can be recorded or edited on
a piano roll display, and there is also a specialized dis-
play for recording and editing the DRUMS part data.
(Refer to page 73 or 74.)
Store a chord progression
Store the chord progression for the AUTO PLAY CHORD in the track for the CHORD part. Then, when
the AUTO PLAY CHORD is used during playback, even if you do not specify the chords with your left
hand, the chords change automatically.
• The chord length is specified with the CHORD STEP RECORD keys on the keyboard.
Note value keys
w
Whole note
h
. Dotted half-note
h
Half-note
q
. Dotted quarter-note
q
Quarter-note
e
Eighth-note
Reset key
Press to begin storing from the begin-
ning.
Correction keys
ᮤ
Move back one step.
ᮣ
Move forward one step.
Repeat key
Press to end the chord-storing proce-
dure and to specify automatic repeat
playback of the stored progression.
End key
Press after the whole chord progres-
sion has been stored.
DELETE key
DELETE
Press to erase data.
• To erase all the data from the current track, while
pressing the DELETE key, press the End key
( ).
wh.h
q.
eq
&
DELETE
&
08_Part III.fm 67 ページ ２００３年５月１６日 金曜日 午後５時４１分