Filter
Top Products
Part V Disk Drive
94
QQTG0701
Disk Drive
Ⅲ
ⅢⅢ
Ⅲ
SMF LOAD
Load data which was saved in the “Standard
MIDI File” (SMF) format.
1.
On the LOAD (PAGE 1/3) display, press the
SMF button.
• The display looks similar to the following.
• For disks which contain SMF files only, this display
appears automatically when LOAD is selected on the
DISK MENU display.
2.
Use the buttons below the display to select the
filename you wish to load.
• If the number of files is 10 or more, you can use the
PREV and NEXT buttons to go back or advance 10 files
at a time.
• If you press the TECH button, the display changes to the
LOAD display for Technics format.
• You can use the INFORMATION button to switch the dis-
played data.
DISK: Disk name
SONG: Song name
3.
Use the TO SONG button to select the num-
ber to load to (this instrument’s SEQUENCER
song number).
• Songs to load are specified one at a time.
• The song name to load to is shown below the TO SONG
button.
4.
Use the LOAD AS button to specify the load
method.
Select from the following.
GM/GM2 → GM2:
Activate the GM2 initialized settings, and
load GM/GM2 data.
NX → NX:
Active the NX SOUND settings, and load
NX data.
GM/GM2 → NX:
Activate the NX SOUND initialized settings,
and load GM/GM2 data.
PREV. TEC → NX:
Activate the NX SOUND initialized settings,
and load SMF data that was saved in the
TECHNICS mode on a previous model.
(The volume balance and octave settings
may differ from the saved settings.)
• If you select the setting which is different from that in
which the song was stored, the sounds, octaves, and
arrangement of percussion instrument sounds, etc. will
be different.
5.
Press the LOAD button.
• The LOAD operation begins.
• When the operation has been successfully completed,
“COMPLETED!” is shown on the display.
• If you press the START/STOP button, playback of the
loaded data begins.
• During the LOAD operation, data that cannot be pro-
cessed by this instrument is ignored.
Ⅲ
ⅢⅢ
Ⅲ
COMPOSER LOAD
Load COMPOSER data only from a disk.
1.
In the RHYTHM GROUP section, press and
hold the LOAD (MEMORY) button for a few
seconds.
• The display looks similar to the following.
2.
Select the name of the file you wish to load.
3.
Press the LOAD button.
• Data is loaded to this instrument’s COMPOSER memory
(MEMORY).
RHYTHM GROUP
METRONOME
POP ROCK
FUNK &
SOUL DISCO
POP BALLAD
BALLAD
BALLROOM
& SHOW
MEMORY
LATIN &
WORLD
JAZZ &
SWING
WALTZ
& TRADUSA16 BEAT8 BEAT
LOAD
10_Part V.fm 94 ページ ２００３年５月１６日 金曜日 午後８時４１分