Filter
Top Products
Part VIII Sound Edit
116
QQTG0701
Sound Edit
Amplitude Edit
Adjust the settings related to the volume of the sound.
LEVEL
1.
On the SOUND EDIT menu, select AMPLI-
TUDE.
• The display looks similar to the following.
• Use the ▲ and ▼ buttons to select a setting item and
then the
∧
and
∨
buttons to specify a selection.
• Select ON/OFF and use the
∧
and
∨
buttons to select
ON or OFF.
2.
Use the buttons to the left of the display to
select a tone.
• item and then the
∧
and
∨
buttons to specify a selection.
3.
Select LEVEL and use the
∧
and
∨
buttons to
select the volume.
4.
Select TOUCH and use the
∧ and ∨
buttons to
set the amount of volume change in relation to
how hard the keyboard is played.
• At a − value, the softer the keyboard is played, the louder
the sound. At a + value, the harder the keyboard is
played, the louder the sound.
5.
Select CURVE and use the
∧
and
∨
buttons to
select the type of volume curve depending on
touch.
6.
Change the respective key follow settings.
• Select KEY FOLLOW SLOPE and use the
∧
and
∨
but-
tons to adjust the bend slope. Select KEY FOLLOW
RANGE (1–3) and use the
∧
and
∨
buttons to specify
the pitch range by note name.
7.
Repeat steps 2 to 6 for the other tones, as
desired.
ENVELOPE
Specify how the volume changes over time, from
the time the key is played to the time the sound
dies out.
1.
Use the PAGE buttons to view the 2/3 display.
• The display looks similar to the following.
• Use the ▲ and ▼ buttons to select a setting item and
then the
∧
and
∨
buttons to specify a selection.
2.
Use the buttons to the left of the display to
select a tone.
3.
Adjust the settings for the volume envelope.
• Use the buttons below the display to set the correspond-
ing values. The envelope is created on the display as you
input the settings.
• Select SUSTAIN PEDAL and use the
∧
and
∨
buttons to
select the type of sustain.
LONG:
Extend the release time of the sound.
HOLD:
Maintain the key-pressed condition.
4.
Repeat steps 2 and 3 for the other tones, as
desired.
ENVELOPE TOUCH & KEY FOLLOW
Specify how the volume changes relative to
touch or note pitch over time.
1.
Use the PAGE buttons to view the 3/3 display.
• Use the ▲ and ▼ buttons to select a setting item and
then the
∧
and
∨
buttons to specify a selection.
2.
Use the buttons to the left of the display to
select a tone.
3.
Change the touch settings.
• Select TOUCH ATTACK and use the
∧ and ∨
buttons to
specify the ATTACK time change depending on touch.
Select TOUCH DECAY and use the
∧
and
∨
buttons to
specify the DECAY time change depending on touch.
• At a − setting, the softer the keys are pressed, the greater
the change. At a + setting, the harder the keys are
pressed, the greater the change.
4.
Change the key follow settings for the
ATTACK, DECAY and RELEASE.
• Select RANGE (1–3) and use the
∧
and
∨
buttons to
specify the keyboard range.
13_Part VIII.fm 116 ページ ２００３年５月２０日 火曜日 午前８時２１分