Filter
Top Products
124 Chapter 11—Matrix Sends
DM2000 Version 2—Owner’s Manual
Viewing Matrix Send Settings
You can view and set the Matrix Send Level and On/Off parameters of all Matrix Sends on
the Matrix View page. If the Auto AUX/MATRIX Display preference is on, and a Bus Out,
Aux Send, or the Stereo Out is currently selected, this page appears automatically when a
SELECTED CHANNEL AUX/MATRIX SEND control is operated. See “Auto
AUX/MATRIX Display” on page 275 for more information.
1 Use the MATRIX SELECT [DISPLAY] button to select the Matrix Send View
page.
2 Use the cursor buttons to select the PRE FADER and POST FADER buttons,
and press [ENTER] to set all Matrix Sends to either pre-fader or post-fader.
3 Use the cursor buttons to select the Output Channel Matrix Sends.
If the Master Layer is currently selected, [SEL] buttons 1–20 can also be used to select Out-
put Channels. Matrix Sends can also be selected by using the MATRIX SELECT [1–4] but-
tons.
4 Use the Parameter wheel or INC/DEC buttons to set the levels of the Matrix
Sends.
5 Use the [ENTER] button to turn on and off the selected Matrix Send.
The various Matrix View page indicators are as follows:
Send level set to –∞.
Send level bar.
Send set to off.
Send level set to nominal.
Send off, level set to nominal.
The level in dB and the on/off values of the currently selected Matrix Send are displayed in
the lower-right corner of the page.
Metering Matrix Send Masters
Matrix Send Master levels can be metered on the Meter pages. See “Metering” on page 127
for more information.
Monitoring Matrix Send Masters
Matrix Send Masters can be assigned to the CONTROL ROOM [ASSIGN 1] or [ASSIGN 2]
button for monitoring. See “Control Room Monitoring” on page 158 for more informa-
tion.