Filter
Top Products
248 Chapter 19—Pro Tools Remote Layer
DM2000 Version 2—Owner’s Manual
Zooming
The cursor buttons can be used to zoom the Edit window as follows.
1 Use the [+INC] (CURSOR MODE) button to select Zoom cursor mode.
The CURSOR MODE section of the display shows “ZOOM.”
In Zoom cursor mode, the cursor buttons work as follows:
•Left cursor button: Zoom out horizontally.
•Right cursor button: Zoom in horizontally.
•Up cursor button: Zoom in vertically.
•Down cursor button: Zoom out vertically.
Making Fine Adjustments to the Selected Region
The cursor buttons can be used in conjunction with the Parameter wheel to make fine
adjustments to the selected region.
1 Use the [+INC] (CURSOR MODE) button to select Select cursor mode.
The CURSOR MODE section of the display shows “SELECT.”
2 While holding down the left cursor button, turn the Parameter wheel to
make fine adjustments to the in point of the selected region.
3 While holding down the right cursor button, turn the Parameter wheel to
make fine adjustments to the out point of the selected region.
The following shortcuts apply.
The following shortcuts can be used in either Navigation or Select cursor mode.
To do this... Do this!
Move the edit cursor to the in point of the
selected region
Double-click the Left cursor button
Move the edit cursor to the out point of
the selected region
Double-click the Right cursor button
To do this... Do this!
Select the track/region below Down cursor button
Select the track/region above Up cursor button
Extend the selection to include the same
region on the track below
USER DEFINED KEYS [4] + Down cursor button
Extend the selection to include the same
region on the track above
USER DEFINED KEYS [4] + Up cursor button
Shorten the selection by unselecting the
region on the lowest track
USER DEFINED KEYS [5] + Down cursor button
Shorten the selection by unselecting the
region on the highest track
USER DEFINED KEYS [5] + Up cursor button
Move the selection (not the audio) back-
wards or forwards
Left cursor button+Right cursor button+Parameter wheel