Filter
Top Products
Editing Events Offline 209
DM2000 Version 2—Owner’s Manual
Editing Events Offline
Automix events can be edited offline on the Event Job and Event Edit pages. Offline editing
can be performed only while the Automix function is stopped.
Event Job Page
On the Event Job page, specified events on specified channels between specified in and out
points can be erased, copied, moved/merged, or trimmed.
1 Use the AUTOMIX [DISPLAY] button to locate the Event Job page.
2 Use the cursor buttons to select the channels to edit, then press [ENTER] to
set them.
You can select multiple Input Channels, Bus Outs, Aux Outs, Stereo Out, and the Fader
Group Master. When you select a channel, its button is highlighted. (You can select multiple
channels.)
ALL SELECT: The ALL SELECT button selects all channels.
ALL CLEAR: The ALL CLEAR button de-selects all channels.
3 Use the cursor buttons to select the IN and OUT parameters, then use the
Parameter wheel, INC/DEC buttons or [ENTER] button to specify the edit
range.
TIME SETTING: The IN and OUT parameters are used to specify the region of Automix
data to be erased, copied, moved/merged, or trimmed. The IN and OUT points can be set
on-the-fly by pressing the [ENTER] button while the IN or OUT button is selected. The
captured timecode values can be edited by using the Parameter wheel or the INC/DEC but-
tons. Press the [ENTER] button to reset the currently selected digits to “00.” Up to eight IN
and OUT timecode values can be captured and stored in the eight Capture memories. Use
the cursor buttons to select the Capture memory number, and use the Parameter wheel or
the INC/DEC buttons to select the Capture memories.
4 Use the cursor buttons to select a Job, then press [ENTER].
The following Jobs are available. Certain Jobs feature an additional parameter below the
TIME SETTING section.
ERASE: The ERASE button erases specified Automix data.
COPY: The COPY button copies specified Automix data. This Job features a SOURCE sec-
tion and COPY TO section (below the TIME SETTING section).