Filter
Top Products
258 Chapter 20—Remote Control
DM2000 Version 2—Owner’s Manual
Using Shuttle & Scrub
The Parameter wheel can be used to shuttle and scrub the external machines.
When the [SHUTTLE] button indicator is lit, the Parameter wheel can be used to shuttle.
When the [SCRUB] button indicator is lit, the Parameter wheel can be used to scrub. Turn
the Parameter wheel clockwise to shuttle/scrub forwards. Turn it counterclockwise to shut-
tle/scrub backwards.
Using the Locator
The LOCATOR section can be used to control the external machines.
LOCATE MEMORY [1–8] buttons
These buttons are used to set and to locate to the eight Locate memories. Locate memories
can be set on the Locate Memory page (see page 260). To set a locate memory on-the-fly,
while holding down the [SET] button, press a LOCATE MEMORY [1–8] button. The
DM2000 must be receiving timecode in order to do this. Once set, the stored position can
be located by pressing the corresponding button. If the button is pressed while the machine
is stopped, the stored position is located. If the button is pressed while the machine is play-
ing, the stored position is located and then playback continues from that position.
When using P2, locate operations are based on the control information received at the
REMOTE port. In order to synchronize the MB2000 Peak Meter Bridge’s time counter, it’s
recommended that you set the DM2000 to the same timecode source as the machine.
[AUDITION] button
This button is used in conjunction with the [PRE], [IN], [OUT], and [POST] buttons for
auditioning. Its indicator lights up while auditioning is on and operation is as follows:
•Press the [PRE] button to locate and audition from the pre-roll point.
•Press the [IN] button to locate and audition from the in point.
•Press the [OUT] button to locate and audition from the out point.
•Press the [POST] button to locate and audition from the post-roll point.
[PRE] & [POST] buttons
These buttons are used to locate the pre-roll and post-roll points. If the [AUDITION] but-
ton indicator is lit, playback starts when a point is located. The pre-roll point is the in point
minus the specified pre-roll time. The post-roll point is the out point plus the specified
SHUTTLE
SCRUB
DISPLAY
LOCATE MEMORY
LOCATOR
12345678
ONLINE
AUDITION
LOOP
MASTER
PRE POST
ROLL
BACK
IN OUT MTR
QUICK
PUNCH
REHEARSAL
SET
RETURN
TO ZERO