Filter
Top Products
Using Talkback & Slate 163
DM2000 Version 2—Owner’s Manual
MONITOR ALIGNMENT ATT & DLY ON/OFF:
These buttons are used to turn on and off the Monitor
Alignment Attenuator and Delay parameters of all Sur-
round speakers. The MONITOR ALIGNMENT diagram
and Surround Channel Attenuator and Delay parameters,
which are displayed when either of these buttons are
selected, allow you to align the surround monitor speak-
ers by attenuating and delaying Surround Channels as
necessary. The Attenuator parameters can be set –∞,
–12 dB to +12 dB in 0.1 dB steps. The Delay parameters
can be set from 0 to 30 msec in 0.02 msec steps.
Patching Slot Inputs to Surround Channels
Individual Slot Inputs can be patched to Surround Monitor Channels as follows.
1 Use the MONITOR [DISPLAY] button to locate the Surround Monitor Patch
page.
2 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
SLOT/CH: This patching matrix is used to patch Inputs 1–16 from each of the six Slots to
the Surround Monitor Channels. Each Slot Input can be patched to only one Surround
Monitor Channel.
LEVEL: These parameters are used to set the monitor level of each Slot.
Using Talkback & Slate
The Talkback function distributes the Talkback mic signal to the Studio Monitor Outs and
any Slot or Omni Outputs specified on the Talkback Setup page.
The TALKBACK LEVEL control sets the level of the built-in talkback micro-
phone.
The [TALKBACK] button has two modes of operation: If it’s pressed once
(i.e., for less than 300 ms), the Talkback function is turned on and remains on
when the button is released. This is Latched mode (this mode can be disabled
on the Talkback Setup page). If it’s pressed and held for longer, the Talkback
function is turned on, but turns off when the button is released. This is
Unlatched mode. The [TALKBACK] button indicator flashes while the Talk-
back function is active.
010
TALKBACK LEVEL
TALKBACK