Filter
Top Products
200 Chapter 17—Automix
DM2000 Version 2—Owner’s Manual
1 Use the AUTOMIX [DISPLAY] button to locate the Fader Edit pages.
The CH1–48 Fader Edit page is shown here.
2 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
The counter in the upper-left corner displays the current timecode position.
Edit Safe buttons: The numbered buttons below each fader bar are Channel Safe but-
tons, which can be used to prohibit automix recording on certain channels. A channel is set
to safe when its button appears highlighted.
You can make all channels safe by selecting one “non-safe” button and double-clicking the
[ENTER] button. A confirmation message appears.
You can cancel all safe channels by selecting one “safe” button and double-clicking the
[ENTER] button. A confirmation message appears.
During recording, events cannot be recorded, or rerecorded on safe channels, although
existing events are played back and faders, Encoders, [ON] buttons, and so on can still be
used, which is useful for rehearsing mix moves. Channel safe settings cannot be changed
during recording.
ABSOLUTE & RELATIVE: These buttons are the same as those on the Main and Memory
pages. See “Automix Main Page” on page 194 for more information.
MOTOR: This button is used to turn the fader motors are on and off for Automix play-
back. The button appears highlighted when the motors are on. The motors cannot be
turned off during recording, and are automatically turned on when recording starts.
TOUCH SENSE: This button is the same as the TOUCH SENSE button on the Automix
Main page (see page 196).
UPDATE: This button is the same as that on the Main and Memory pages. See “Automix
Main Page” on page 194 for more information.
EDIT OUT: The TAKEOVER and RETURN buttons are the same as those on the Main and
Memory pages. See “Automix Main Page” on page 194 for more information. The TIME
parameter determines the time it takes faders to return to levels specified by the existing
Automix data when the Edit Out mode is set to Return. It can be set from 0.0 to 30.0 seconds
in 0.1 second steps.