Filter
Top Products
Side panel
This slot is for installation of a separately sold SCSI board or USB board (planned for release).
which a mic or line-level device can be connected.
• GUITAR/BASS:
This is a phone jack to which a passive-
type electric guitar or bass can be connected directly.
These jacks are given priority in the order of GUITAR/BASS
→ UNBALANCE → BALANCE. For example, if all three are
connected, the GUITAR/BASS jack will be selected.
(2)[INPUT 2] jacks
These are the input jacks for INPUT 2. When connecting a
stereo output device, use these jacks in conjunction with
the [INPUT 1] jacks. Select and use one of the following
two jacks.
• BALANCE:
This is an XLR balanced jack to which a mic
or line-level device can be connected.
• UNBALANCE:
This is an unbalanced phone jack to
which a mic or line-level device can be connected.
If both jacks are connected, the UNBALANCE jack will be
selected.
(3)[OUTPUT] jacks
These jacks output the signal that has passed through the
MASTER fader. The following three jacks can be used
simultaneously.
• MASTER:
These are RCA phono analog output jacks.
• PHONES:
A pair of stereo headphones can be connected
to this jack. Use the knob beside this jack to adjust the
headphone volume.
• DIGITAL:
This is an optical-type digital output jack.
(4)[EXP PEDAL] jack
A separately sold expression pedal (ZOOM FP01, FP02)
can be connected to this jack.
(5)[FOOT SW] jack
A separately sold foot switch (ZOOM FS01) can be
connected to this jack.
(6)[MIDI IN] connector
MIDI messages can be input from this connector.
(7)[MIDI OUT] connector
MIDI messages can be output from this connector.
(8)[PHANTOM ON/OFF] switch
When this switch is on, +48V phantom power will be
supplied to the two [INPUT 1/2] BALANCE jacks.
If devices that do not require phantom power are
connected to the [INPUT 1/2] BALANCE jacks, you must
turn this switch off.
(9)[POWER] switch
This switch turns the power of the MRS-1044 on/off.
When turning off the power of the MRS-1044, you must use
the [POWER] switch. If you turn the power off by simply
disconnecting the AC adaptor plug, the previously recorded
content or changes will be lost.
(10)
[DC 12V] jack
Connect the included AC adaptor to this jack.
NOTE
NOTE
NOTE
NOTE
ZOOM MRS-1044
13
Parts of the MRS-1044 and what they do
Rear panel