Filter
Top Products
2.
Press one of the status keys (1 – 6, 7/8, 9/10) or use
the dial to select the track to be captured.
It is not possible to capture a track that has not yet been
recorded.
3.
Press the [ENTER] key.
The display will ask "CAPTURE SURE?"
4.
To execute the Capture operation, press the
[ENTER] key once again.
When the capture is completed, the display will indicate
"SWAP," and you will be able to execute the Swap
operation for that track.
5.
Press the [EXIT] key.
You will return to the main screen.
If necessary, you can repeat steps 2 – 4 to capture multiple
tracks.
The captured data will be erased from the hard disk when
the currently selected project is saved.
Here's how to swap (exchange) the captured data with the
current recorded data of a track.
1.
In the main screen, press the [UNDO/REDO] key.
2.
Press one of the status keys (1 – 6, 7/8, 9/10) or use
the dial to select a track that was previously
captured.
When a captured track is selected, the display will indicate
"SWAP."
If you select a track that has not been captured, the display
will indicate "CAPTURE."
3.
Press the [ENTER] key.
The display will ask "SWAP SURE?"
4.
To execute the Swap operation, press the [ENTER]
key once again.
The recorded data of the selected track will be exchanged
with the previously captured recorded data. The recorded
data of the selected track will be saved as capture data on
the hard disk until the project is saved.
You can return to the previous state by immediately
executing Swap a second time.
5.
Press the [EXIT] key.
You will return to the main screen.
HINT
HINT
Swapping with the captured data
NOTE
HINT
NOTE
ZOOM MRS-1044
45
Reference [Recorder]
Capturing the recorded contents of a track