Filter
Top Products
6.
When the desired note name appears, watch the
">" and "<" symbols in the display, and make fine
adjustments to the tuning.
7.
If you want to change the reference pitch of the
tuner, turn the dial.
The reference pitch of the tuner is set to middle A=440 Hz
by default. The reference pitch can be adjusted in a range
of 435 – 455 Hz.
If you change the reference pitch, the pitch of the bass
program will also change accordingly.
8.
When you have finished tuning, press the [EXIT]
key.
You will return to the main screen. At the same time, the
insert effect will remain bypassed, but the send/return
effects will be switched back on.
9.
To disable bypass for the insert effect, press the
[BYPASS/TUNER] key.
Preventing digital copying of
your master tape
When mixing down to a DAT recorder etc. via the
[DIGITAL] jack, you can prevent digital copies from being
made from your completed master tape onto another digital
recorder. The procedure is as follows.
1.
In the main screen, press the [PROJECT/UTILITY]
key.
The display will indicate "PROJECT."
2.
Use the cursor [
E
]/[
R
] keys to make the display
show "UTILITY SYSTEM," and press the [ENTER]
key.
3.
Use the cursor [
E
]/[
R
] keys to make the display
show "UTILITY D PRTCT," and press the [ENTER]
key.
The current digital copy setting will be displayed.
• OFF:
Digital copying from your master tape to another
digital recorder will be permitted (default setting).
• ON:
SCMS (Serial Copy Management System) data will
be added to the digital signal that is output from the
[DIGITAL] jack. It will not be possible to make digital
copies from a master tape that contains this data.
MRS-1044
Digital copying is
possible
Digital copying is
not possible
[OUTPUT] (DIGITAL) jack[OUTPUT] (DIGITAL) jack
MRS-1044
MD/DAT recorderMD/DAT recorder
MD/DAT recorderMD/DAT recorder
(D PRTCT=ON)(D PRTCT=OFF)
MixdownMixdown
HINT
Reference pitch of the tuner
Correct pitch
Pitch is sharp
Pitch is flat
ZOOM MRS-1044
93
Reference [Other]
Preventing digital copying of your master tape